In this section:
How do I get my LAN or web connection to work? ................. 13-1
Why can't I close a channel? .................................................. 13-1
How do I know if an error has occurred on my instrument? ... 13-2
How do I find the serial number and firmware version? ......... 13-3
Why can't the Series 3700A read my USB flash drive? .......... 13-3
How do I get my LAN or web connection to work?
For troubleshooting suggestions, see Troubleshooting LAN interfaces (on page 12-5).
For more detailed information on remote interface connections, see Remote communications
interfaces (on page 2-6).
Why can't I close a channel?
The channel might be set to be forbidden to close.
To check the forbidden state of a channel from the front panel:
1. Display a channel (you might need to press DISPLAY).
2. Use the navigation wheel to select the channel you want to check.
3. Press CONFIG, then press CHAN.
4. Select FORBID.
5. Press ENTER.
6. Yes and No are displayed. The current selection blinks. To change the setting to allow the
channel to close, select No.
To check the forbidden state of a channel from the web interface:
1. From the list on the left, select the slot that contains the channel.
2. Right-click the channel. The Channel Configuration dialog box is displayed.
To Next Page
Loading...
Need help?
General
