21
6
6
Driving your vehicle Idle Stop and Go (ISG) system
3) Release the brake pedal only
䳜 Late restart function is only oper
-
ated when it is on a level ground
and the vehicle is stable.
䳜 To start the engine when the
brake is not pressed or the gear is
already engaged, for safety press
the brake pedal first and then
press the clutch pedal.
䳜 To turn on the engine without
vehicle movement with the brake
pedal pressed, (only with Late
Restart)
1. Press and release the clutch
pedal
2. Press the clutch pedal again
immediately
䳜 After the vehicle stalled, the
engine starts if you operate as
shown below (only with Late
Restart)
1. Release the clutch pedal, after
the engine completely stop
2. Depress the clutch pedal
䳜 After operating ISG STOP, if the
vehicle speed increases instead of
decreasing, the engine may
restart automatically.
Automatic Transmission/Dual
Clutch Transmission
䳜 Release the brake pedal
After operating ISG STOP, if the
vehicle speed increases instead of
decreasing, the engine may restart
automatically
Condition of ISG system operation
The ISG system will operate under
the following condition:
䳜 The driver䳓s seatbelt is fastened
䳜 The driver䳓s door and bonnet are
closed
䳜 The brake vacuum pressure is
adequate
䳜 The battery sensor is activated
and the battery is sufficiently
charged
䳜 Outside temperature is not too
low or too high
䳜 The climate control system satis
-
fies the conditions
䳜 The vehicle is sufficiently warmed
up
䳜 The vehicle is not on a steep road
grade (Excluding : Manual Trans
-
mission)
䳜 The steering wheel is not at a
sharp angle
䳜 The vehicle is not at a high eleva
-
tion
䳜 The front windscreen defroster is
off
䳜 You have not selected Manual
shift mode (Excluding : Manual
Transmission)
To Next Page
Loading...
Need help?
General
