101
6
6
Driving your vehicle Manual Speed Limit Assist (MSLA)
Function operation
To set speed limit
1. Press the speed limit but
-
ton twice on the steering wheel,
to turn the function on.
The speed limit indicator light will
illuminate.
2. Move the switch down (to SET-).
3. Move the switch up (to RES+) or
down (to SET-), and release it at
the desired speed. Move the
switch up (to RES+) or down (to
SET-) and hold it.The speed will
increase or decrease by 5 km/h (3
mph).
The set speed limit will be displayed
on the cluster.
To drive over the preset speed limit
you must depress hard on the
accelerator pedal (more than
approximately 80%) until the kick
down mechanism works with a
clicking noise. Then the set speed
limit will blink and chime will sound
until you return the vehicle speed
within the speed limit.
䳜 Depressing the accelerator pedal
less than approximately 50%, the
vehicle will not speed over the
To Next Page
Loading...
Need help?
General
