• When the starting switch is turned to ON position,
the secondary steering self-check function may
operate.
When the standard screen is displayed while the
self-check is in operation, the secondary steering
pilot lamp (11) lights up.
REMARK
While the secondary steering self-check function is in
operation, the machine monitor may go out temporari-
ly or restart, but it is not a trouble.
If the gear shift lever is in any position other than NEUTRAL position (N) when the starting switch is
turned to ON position, the shift lever position pilot lamp (12) of that position starts flashing, the central-
ized warning lamp lights up, and the alarm buzzer sounds intermittently.
Turning the starting switch to START position in this state does not start the engine.
Turn the gear shift lever to NEUTRAL (N) position, and the centralized warning lamp goes out, the
alarm buzzer stops sounding, and the engine can be started.
9.
When the caution lamp stays lit, press ENTER switch, and
“Current Abnormality” screen is displayed.
For the contents and check methods for caution lamp, see
“WARNING DISPLAY (3-17)”.
10.
When the maintenance time caution lamp lights up in red,
press the menu switch and “Maintenance” menu screen is
displayed.
For the method of checking the maintenance time, see
“MAINTENANCE SCREEN SETTING (3-81)”.
Maintenance time caution lamp is lit for 30 seconds.
METHOD FOR STARTING ENGINE
WARNING
• Start the engine only while sitting on the operator's seat.
• Do not attempt to start the engine by short-circuiting the engine starting circuit.
This may cause fire, serious personal injury or death.
• Check that there is no person or obstacle in the area around the machine, then sound the horn and
start the engine.
• Never use the starting aid fluids to start the engine as they may cause explosions.
• Exhaust gas is toxic.
When starting the engine in confined spaces, be particularly careful to ensure good ventilation.
OPERATION MACHINE OPERATIONS AND CONTROLS
3-193
To Next Page
Loading...
Need help?
General
