1.
Open the engine side cover.
2.
Pump in the grease through the grease fittings shown by
arrows by using a grease pump.
3.
After greasing, wipe off any old grease that is pushed out.
4.
Close the engine side cover.
EVERY 2000 HOURS MAINTENANCE
Maintenance for every 250, 500, and 1000 hours services should be performed out at the same time.
METHOD FOR REPLACING STEERING AND HOIST OIL FILTER ELEMENT
WARNING
• Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn in-
jury.
Wait for the temperature to go down, and then start the work.
• When removing the oil filler cap, the oil may spurt out. Turn it slowly to release the internal pres-
sure, then remove it carefully.
1.
Stop the engine.
2.
Turn the cap of oil filler port (F) to release the internal pres-
sure before removing the cap.
MAINTENANCE MAINTENANCE PROCEDURE
4-69
To Next Page
Loading...
