• Check braking performance of secondary brake
• Check automatic secondary steering
• Check manual secondary steering
• Check automatic secondary steering
• Check dump body positioner operation
• Check backup alarm operation
• Check horn operation
EVERY 250 HOURS MAINTENANCE
METHOD FOR LUBRICATING
1.
Stop the engine.
2.
By using a grease pump, pump in grease through the grease fitting.
3.
Check visually that the greasing has been performed properly.
4.
After greasing, wipe off any old grease that is pushed out.
Perform the greasing work every day when operating the machine in the places where the grease flows out
easily, such as when traveling through mud or water.
Dump body hinge pin (1 place each of right and left)
Rear suspension (2 places each of right and left)
Rear axle support (4 places each of right and left)
The positions (a) are the integrated lubrication points (4 pla-
ces).
MAINTENANCE MAINTENANCE PROCEDURE
4-39
To Next Page
Loading...
Need help?
General
