Konica Minolta bizhub 3301P User Manual

User's Guide
- 80 -
Universal Setup menu
Use
To
Units of Measure
Inches
Millimeters
Identify the units of measure.
Notes:
• Inches is the US default setting.
• Millimeters is the Non-US default setting.
Portrait Width
3–8.5 inches
76–216 mm
Set the portrait width.
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• 8.5 inches is the US default setting. You can increase the width in
0.01-inch increments.
• 216 mm is the Non-US default setting. You can increase the
width in 1-mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Set the portrait height.
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• 14 inches is the US default setting. You can increase the height
in 0.01-inch increments.
• 356 mm is the Non-US default setting. You can increase the
height in 1-mm increments.
Feed Direction
Short Edge
Long Edge
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.

Konica Minolta bizhub 3301P Specifications

General

Brand	Konica Minolta
Model	bizhub 3301P
Category	Printer
Language	English