91PERIODIC SERVICE
C Greasing the articulation joint
Apply grease to the articulation joint at one grease fitting.
C Greasing the steering cylinder bearing
Apply grease to the steering cylinder bearing at the two
grease fittings.
BChecking tire pressure, wear and wheel
nuts
Refer to the section on "TIRES".
BChecking and cleaning the radiator and oil
cooler
1. Open the engine cover.
2. Check the fins and ribs for clogging. If clogged, they
should be cleaned out with a jet of compressed air or
water.
3. Check the cooling water hoses for damage. If broken
or cracked, change them. Also, check to see that the
hose clamps are tight.
A Radiator and oil cooler fins and ribs must be clean in
order not to overheat the engine and allow free flow of
air through the cooling elements.
A Pressure of compressed air must be under 205 kPa
(2.1 kgf.cm , 30 psi)
A When cleaning the radiator and oil cooler with
compressed air, the fins can be damaged. Pay
attention not to damage
BChecking the steering
1. Start the engine, turn the steering wheel left and right
and check the operation.
2. If any abnormality is found, have the steering
inspected further by your KUBOTA dealer.
(1) Grease fitting
(1) Grease fittings
(1) Radiator grill
(2) Oil cooler
To Next Page
Loading...
Need help?
General
