25CHECKS BEFORE START
A Aux hold switch will be cancelled, if you operate AUX
port variable switch when press aux hold switch.
BFloat Switch
To avoid personal injury or death:
A Make sure the bucket is lowered to the ground
before putting the lift arms in the "FLOAT"
position. Putting the lift arms in the "FLOAT"
position while they are off the ground will
cause the bucket and lift arms to fall and is
extremely dangerous.
A Do not drive the machine forward with the lift
arms in the "FLOAT" position.
To fix the float position, press the float switch and the
control lever can be held in the float position.
[R630]
SAFETY LEVERS AND APPLIANCE
BSafety Key Start System
This is the safety system to prevent the machine from
moving suddenly.
The direction switch is to be set to the neutral position
before stopping the engine.
The safety key start system does not allow the engine to
start when the parking brake is released.
BLift Arm Support
To avoid personal injury or death:
A Before installing the lift arm support, remove
the front attachment set the direction switch to
the neutral position, lock all control levers in
neutral, and remove the key.
The lift arm support is used to prevent the loader lift arms
from falling when servicing the machine.
Install as follows.
1. Remove the front attachment.
2. Raise the loader lift arms completely.
3. Stop the engine and remove the key.
4. Insert the lift arm support onto the lift cylinder rod.
5. Install the pin and snap pin in the lift arm support.
6. Slowly lower the loader lift arms onto the lift arm
support.
(1) Aux port variable switch (A) "Port A"
(B) "Port B"
(1) Float switch
(1) Lift arm support device (Storage position)
To Next Page
Loading...
Need help?
General
