EasyManuals Logo

Kubota R630 User Manual

Kubota R630
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
PERIODIC SERVICE100
2. Fill engine oil into the oil port up to the correct level.
3. Idle the engine for a short while. About 5 minutes after
stopping the engine, check the oil level with the oil
dipstick.
A Use engine oil of appropriate viscosity according to
ambient temperature.
A Change the engine oil once every 6 months regardless
of the running time on the machine.
A Change the oil filter when you change the oil.
BReplacing the engine oil filter cartridge
To avoid personal injury or death:
A Always stop the engine before replacing the
engine oil filter cartridge.
A Never remove the oil filter immediately after the
engine has stopped, or hot engine oil may rush
out, causing scalding.
1. Replace the engine oil filter cartridge at the same time
engine oil is changed.
2. Use the supplied filter wrench to remove the oil filter.
3. Apply a thin layer of oil to the gasket of the oil filter and
firmly tighten it in place by hand.
4. Top up oil if necessary.
5. Idle the engine briefly.
6. Check the oil level about 5 minutes after switching off
the engine with the oil dipstick.
(1) Oil port
(2) Oil dipstick
(A) Proper oil level
Oil capacity
Engine oil 9.0 L (2.4 U.S.gal.)
(1) Engine oil filter cartridge

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota R630 and is the answer not in the manual?

Kubota R630 Specifications

General IconGeneral
Engine Power64.4 HP
TransmissionHydrostatic
Travel Speed12.4 mph
Hydraulic Pump Flow17.4 GPM
Horsepower64.4 HP
Hydraulic System Flow17.4 GPM
Lift Height106.3 in (2, 700 mm)
Fuel Tank Capacity21.1 gal
Overall Width66.9 in (1, 700 mm)
Overall Height85.4 in (2, 170 mm)

Related product manuals