OPERATION OF THE ENGINE44
STARTING WITH AN AUXILIARY BATTERY
To avoid personal injury or death:
A Battery gases can explode.
Do not smoke and keep sparks and flames
away.
A Do not start the engine with an auxiliary battery
if machine battery is frozen.
A Do not connect the black jumper cable to the
negative (-) terminal of the machine battery.
BObserve Following Guidelines when
Starting with an Auxiliary Battery
1. Bring the helping machine with the same battery
voltage as near as possible to the machine.
THE MACHINES MUST NOT COME IN CONTACT
WITH EACH OTHER.
2. Bring the levers and pedal of both machines in the
neutral position.
3. Wear eye protection and rubber gloves.
4. Ensure the vent caps are securely in place (if
equipped).
5. Connect the terminal of the red jumper cable with the
plus (+) terminal of the low battery and connect the
other end of the cable to the plus (+) terminal of the
auxiliary battery.
6. Connect the black negative cable to the minus (-)
terminal of the auxiliary battery.
7. Connect the other end of the black cable (coming from
the auxiliary battery) to the conductive part of the
machine frame as far away as possible from the low
battery.
8. Start the engine of the helping machine and let it run
for a while. Start the machine with the low battery.
9. Disconnect the jumper cables in the reverse
sequence.
A This machine has a negative (-) ground 12 Volt starting
system.
A Only use the same voltage when using an auxiliary
battery.
A Using a higher voltage will cause serious damage to
the electrical system. When using an auxiliary battery,
only the compatible (same) voltage is permissible.
(1) Low battery
(2) Auxiliary battery
(3) Jumper cables
To Next Page
Loading...
Need help?
General
