OPERATION OF THE MACHINE70
C To approach slowly
1. Press the inching and brake pedal slightly while
pressing the accelerator pedal. The machine
approaches slowly.
2. The machine can slowly approach an object by
accelerator pedal regulation only, without inching and
brake pedal operation.
C To scoop during digging
In case of the bucket does not raise up during digging,
press the inching and brake pedal.
Traction force is reduced and lifting force is increased, if
the inching and brake pedal is pressed.
BUsing the Inching and Brake Pedal
According to the Job
To avoid personal injury or death:
A When traveling with a fully-loaded bucket, do
not press the inching and brake pedal all the
way. The machine will brake abruptly and
cause dangerous loss of balance that may
cause an accident.
C Loading
1. Press the inching and brake pedal slightly while
pressing the accelerator pedal to approach an object
slowly.
Slow approach can be done also by regulating
accelerator pedal operation.
2. The bucket can be operated at the maximum engine
rpm when the inching and brake pedal is used to
approach slowly. Bucket operation speed is thus
maintained.
3. Press the inching and brake pedal slightly to allow the
machine to approach to the desired stop position.
Then press the pedal all the way to stop the machine
completely.
(A) Press the pedal slightly
(A) Press the pedal fully
(B) Release the pedal
(A) Press the pedal slightly
To Next Page
Loading...
Need help?
General
