105PERIODIC SERVICE
A If there are deposits in the tank, wipe them all with a
clean rag and diesel oil.
A Use great caution not to admit any foreign particles
into the tank.
BReplacing air cleaner element
Open the hood, and remove the cover and both filter
elements, change both filter elements and clean the
inside of the case. Reinstall the filter elements and the
cover being careful to install the cover so that its TOP
mark (arrow) faces upwards.
BAdjusting Engine Valve Clearance
Consult your local KUBOTA dealer for this service.
EVERY 1500 SERVICE HOURS
Perform inspection and servicing for every 50, 250 and
500 hours of operation at the same time.
BChecking Injector Tip
Consult your local KUBOTA dealer for this service.
BReplacing Oil Separator Element
To avoid personal injury or death:
A Be sure to stop the engine before replacing the
oil separator element.
1. Remove the cover and take out the element. Wipe off
oil and the carbon in the case with a clean rag.
2. Fit a new oil separator element and O ring.
3. Tighten the cover until a cover comes in contact with
body.
(1) Oil port cap
Hydraulic oil
volumes
Hydraulic tank
39 L
(10.3 U.S.gal.)
Whole oil volumes
60 L
(15.9 U.S.gal.)
(1) Outer element
(2) Inner element
(3) Cramp
(4) Cover
(1) Oil separator
To Next Page
Loading...
Need help?
General
