-5SAFE OPERATION
31.Do not allow children to operate the machine.
32.Do not allow children to play around the machine.
C Avoiding crystalline silica (quartz) dust
To avoid serious injury or death from silica dust:
Avoid exposure to dust containing crystalline silica
particles.
This dust can cause serious injury to the lungs (silicosis).
Because crystalline silica is a basic component of sand
and granite, many activities at construction sites produce
dust containing crystalline silica.
Trenching, sawing and boring of material containing
crystalline silica can produce dust containing crystalline
silica.
If dust which contains crystalline silica is present, there
are guidelines which should be followed:
1. Be aware of the potential health effects of crystalline
silica and that smoking may add to the damage.
2. Be aware of and follow OSHA (or other local, State or
Federal) guidelines for exposure to airborne crystalline
silica.
3. Know the work operations where exposure to
crystalline silica may occur.
4. Participate in air monitoring or training programs
offered by the employer.
5. Be aware of and use optional equipment controls such
as water sprays, local exhaust ventilation, and
enclosed cabs with positive pressure air conditioning if
the machine has such equipment. Otherwise
respirators shall be worn.
6. Where respirators are required, wear a respirator
approved for protection against crystalline silica
containing dust. Do not alter the respirator in any way.
Workers who use tight-fitting respirators cannot have
beards/mustaches which interfere with the respirator
seal to the face.
7. If possible, change into disposable or washable work
clothes at the work site; shower and change into clean
clothing before leaving the work site.
8. Do not eat, drink, use tobacco products, or apply
cosmetics in areas where there is dust containing
crystalline silica.
9. Store food, drink and personal belongings away from
the work area.
10.Wash hands and face before eating, drinking,
smoking, or applying cosmetics after leaving the
exposure area.
4. TRAVELING
1. Before traveling on the public road, observe all local
and state traffic regulations. Use SMV emblem and
warning flashers as required.
(SMV: Slow Moving Vehicle)
2. Traveling on the public road
Please note the following points:
(1) Raise the lift arm.
(2) Fully tilt the bucket.
(3) [R530]
Lock the control lever and the auxiliary port lever
by pulling the control lever lock and the auxiliary
port lever lock.
[R630]
Lock the control lever by pressing the hydraulic
lock switch.
3. When traveling on a public road, lock the bucket and
attachments securely so that they cannot lower, even
if any control lever is operated. Lift the bucket about 40
cm (16 in.) above the ground and set it in the proper
position for travel, then lock the control lever.
4. First check the area around the machine, then
gradually increase the engine rpm and slowly move
the machine. Do not move the machine abruptly. To
move the machine on a steep slope, press the
accelerator pedal gradually while releasing the inching
and brake pedal so that the machine does not move
backwards.
5. The steering wheel for this machine will not return to
the starting position after turning a bend. Be sure to
turn the wheel to the starting position by yourself.
6. When operating the machine, obey all safety signals
and traffic signs.
7. Use the brake when the machine begins to accelerate
by itself.
(1) SMV emblem
To Next Page
Loading...
Need help?
General
