Copy Functions
ADVANCED OPERATION GUIDE 1-13
Border Erase Mode
Shadows that appear around the edges of copies can be erased. The
following modes are available:
NOTE: To set the default value for Border Erase width, refer to Border
Erase Width Default Value, on page 3-12.
1
Position the original and press
[Border Erase].
2
Press S or T to select Sheet
Erase or Book Erase and press
[Enter].
3
Press < or > to set the Border
Erase Width, 1/8" to 3/4" in 1/8"
increments (1 mm to 18 mm in 1
mm increments) can be selected.
Press [Enter].
4
Press [Start]. Copying commences.
Mode Description
Sheet Erase Use this mode to erase shadows which appear when using
sheet originals. You can set the width of the border to be
erased from 1/8" to 3/4" in 1/8" increments (1 mm to 18 mm in
1 mm increments).
Book Erase Use this mode to produce clean copies from a thick book. You
can set the width of the border to be erased from 1/8" to 3/4" in
1/8" increments (1 mm to 18 mm in 1 mm increments).
Margin:
Left Margin
Top Margin
Border Erase:
Sheet Erase
Book Erase
1/8"
Border Erase Width:
1/4" 3/4"
To Next Page
Loading...
Need help?
General
