Kyocera KM-1650 Advanced Operation Guide

Printer Settings
2-18 ADVANCED OPERATION GUIDE
Emulation
The following settings are available:
• Emulation Mode Selection
• KC-GL Pen Thickness
• KPDL Error Printing
• KPDL (AUTO) Alternative Emulation Selection
NOTE: You can set the emulation for each interface.
Emulation Mode Selection
Emulation modes that can be used with this machine: PCL6, KC-GL,
KDPL, KDPL (AUTO), Line Printer, IBM Proprinter, Diablo 630, EPSON
LQ-850
If you set KC-GL, you can set the thickness of the pen and page size.
If you set KPDL (AUTO), switching between KPDL and an alternative
emulation mode will be automatically performed according to the print
data.
If you set KPDL or KPDL (AUTO), the details of any error that occurs during
printing can be printed.
1
Press [Printer].
2
Press S or T to select MENU
and press [Enter].
3
Press S or T to select Emulation
and press [Enter].
4
Press S or T to select the
interface and press [Enter].
5
Press S or T to select the
emulation mode and press
[Enter].
GO
CANCEL
Ready
MENU
Print Status Page
Menu
Interface
Emulation
Back
Parallel
Interface
Network
Back
PCL 6
Emulation
KC-GL

Kyocera KM-1650 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Max Resolution	600 x 600 dpi
Paper Capacity	300 sheets
Memory	32 MB
Functions	Print, Copy, Scan
Type	Monochrome
Grayscale Half-Tones	256 levels
Max Document Enlargement	200%
Max Document Reduction	50%
Output Trays Capacity	250 sheets
Monthly Duty Cycle	15, 000 pages
Scan Type	Flatbed
First Copy Out Time B/W	5.9 seconds
Supported Media Type	Plain paper
Max Media Capacity	1, 300 sheets
Interface	USB 2.0
Original Size	A3 (11.7 in x 16.5 in) (max)