Kyocera KM-1650 Advanced Operation Guide

Printer Settings
ADVANCED OPERATION GUIDE 2-51
Auto Continue
If any of the following error messages appear, the error can be cleared and
printing can be continued after the preset recovery time elapses (auto
continue).
• Memory Overflow
• Print overrun
• KPDL error
• File not found
• HARD DISK error
• RAM disk error
• MemoryCard err
• Illegal Account
• Exceeded Max.out
• Account error
• Duplex disabled
•Add Staples
• e-MPS not stored
• Opt. ROM error
You can also set the time that elapses before Auto Continue is activated.
1
Display the Others screen, refer to Access the Others Screen, on page 2-
48.
2
Press S or T to select Auto
Continue and press [Enter].
3
Press S or T to select On or Off
and press [Enter]. If you have
selected On, Change # displays.
4
To set the time that elapses
before Auto Continue is activated,
press S or T to select Change #
and press [Enter].
The Auto Continue (time) screen displays.
5
Press < or > to select the time, 0
to 495 seconds in 5 second
increments can be selected.
Press [Enter].
6
Press [Reset]. The Printer Basic screen displays.
Auto Continue
Resource Prot.
Others
Printer Reset
Back
On
Auto Continue
Off
Change #
On
Auto Continue
Off
(0
Auto Continue (Time)
30 495)sec.

Kyocera KM-1650 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Max Resolution	600 x 600 dpi
Paper Capacity	300 sheets
Memory	32 MB
Functions	Print, Copy, Scan
Type	Monochrome
Grayscale Half-Tones	256 levels
Max Document Enlargement	200%
Max Document Reduction	50%
Output Trays Capacity	250 sheets
Monthly Duty Cycle	15, 000 pages
Scan Type	Flatbed
First Copy Out Time B/W	5.9 seconds
Supported Media Type	Plain paper
Max Media Capacity	1, 300 sheets
Interface	USB 2.0
Original Size	A3 (11.7 in x 16.5 in) (max)