Kyocera KM-1650 Advanced Operation Guide

Printer Settings
2-46 ADVANCED OPERATION GUIDE
1
Display the Paper Handling screen, refer to Access the Paper Handling
Screen, on page 2-44.
2
Press S or T to select Duplex
Mode and press [Enter].
3
Press S or T to select Short
edge bind or Long edge bind and
press [Enter].
4
Press [Reset]. The Printer Basic screen displays.
Output Destination
Use to set the paper Output Destination.
NOTE: This item is displayed only if the optional Finisher or Job
Separator is installed.
1
Display the Paper Handling screen, refer to Access the Paper Handling
Screen, on page 2-44.
2
Press S or T to select Stack
Select and press [Enter].
3
Press S or T to select the paper
output destination and press
[Enter].
4
Press [Reset]. The Printer Basic screen displays.
Paper Handling
Bypass Mode
Feed Select
Duplex Mode
Duplex Mode
Back
None
Short Edge Bind
Setting Output destination
Top Tray Main body output tray
Finisher Optional Finisher
Job Separator Optional Job Separator
Bypass Mode
Paper Handling
Feed Select
Stack Select
Back
Top Tray
Select Output Tray
Finisher

Kyocera KM-1650 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Max Resolution	600 x 600 dpi
Paper Capacity	300 sheets
Memory	32 MB
Functions	Print, Copy, Scan
Type	Monochrome
Grayscale Half-Tones	256 levels
Max Document Enlargement	200%
Max Document Reduction	50%
Output Trays Capacity	250 sheets
Monthly Duty Cycle	15, 000 pages
Scan Type	Flatbed
First Copy Out Time B/W	5.9 seconds
Supported Media Type	Plain paper
Max Media Capacity	1, 300 sheets
Interface	USB 2.0
Original Size	A3 (11.7 in x 16.5 in) (max)