1-6 Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)
Turning TTI Transmission ON/OFF (TTI setting)
The TTI (Transmit Terminal Identifier) refers to information – such as the
time of the transmission, the number of pages, your station name and
fax number, etc. – that is automatically sent to the receiving party's fax
and printed out on the received documents. With this fax, you can select
here whether or not that TTI information will be sent to the receiving
party's fax, and – if it is – whether it will be printed inside or outside the
border of the transmitted page.
1 Press the System Menu/Counter key. The System Menu / Counter
screen will appear.
2 Press the [FAX Default] key.
3 Press the [T] cursor key until TTI is highlighted and then press the
[Change #] key.
4 If you want your TTI information to be sent to the other party, press
the desired location where you want it to be printed.If you do NOT
want it to be sent, press the [Not Printed] key.
5 Press the [Close] key. The message display will return to the same
screen as was displayed in step 3.
6 If you are finished making settings, press the Reset key to return to
the initial mode.
Note Prior to operation, check the message display to make sure
that the touch panel is in the initial mode for fax operation. (Refer
to What is the Initial Mode? on page 1-9.)
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode screen.
Ordinarily, the registered self-station name will be displayed as
part of the TTI, but, if Restricted Access is turned ON and the
transmission is initiated by entering an ID-code, the department
name corresponding to that ID-code will be displayed.
System Menu
Default
Copy
Default
FAX
Language
Setting
MP Tray
Orig. Size
Register
Default
Machine
Accou
To Next Page
Loading...
Need help?
General
