Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax) 1-7
Registering the Information Identifying Your
Facsimile (Location Info. setting)
If you register information identifying your station (fax number, station
name and station ID) here, it can be sent to the receiving party's fax and
printed on the received documents, thereby instantly notifying that party
of the source of the fax transmission.
1 Press the [Register] key. The Register screen will appear.
2 Press the [Location Info.] key. The currently registered information
will be displayed.
3 Registering your fax number
Use the numeric keys to enter your fax number.
4 Press the [OK] key. The message display will return to the same
screen as was displayed in step 2.
5 Registering your station name
Note Use the following procedure as well when you want to
change information that is already registered.
Prior to operation, check the message display to make sure that
the touch panel is in the initial mode for fax operation. (Refer to
What is the Initial Mode? on page 1-9.)
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode screen.
Place the original & assign destination.
Dest
Ready for fax transmission.
Basic Application
Abbrev.
TXAddress
Register
settingbook
Print Report
Info.
Location
Dial
Basic Application Register
Box
Forwarding
Fax
dial
Remote SW
Test ID
Remote
Restrict.
TX/RX
Print Report
Registering item option screen.
Select item for register.
& Time
Date
key
Encryption
Regist'd contents cnf
Program Fax Parameter.
Own Name
Own ID 0000.
Note To register your fax number: Press the [] key and go to
step 3. To register your station name: Press the [Own Name] key
and go directly to step 5. To register your station ID: Press the
[Own ID] key and proceed directly to step 7.
Delete
Enter using # key.
Own location tel # Ba
Program Fax Parameter.
(MAX. 20 digits)
Space
Note The fax number can be up to 20 digits in length.
If you want to clear the currently displayed number from the
message display, simply press the Stop/Clear key.
If you want to revise the entered number, press the [] or []
cursor key to move the cursor to the number that you want to
change. Then press the [Delete] key to delete that number
and enter the correct number as desired.
To Next Page
Loading...
Need help?
General
