3-10 Fax Operation (Advanced)
Sending Documents at a Specified Time
(Communication Using the Timer)
If you designate in advance the time for a communication to begin, that
communication will be carried out automatically once the appointed time
is reached. You can designate a communication to be one that uses the
timer during the operation procedure for each of various types of fax
communication available in this fax such as Broadcast Transmission.
The example in the procedure below is for the transmission of
documents to a single destination using the timer function.
1 Set the documents you want to transmit in the Document Processor
or on the platen.
2 Enter the destination fax number.
IMPORTANT If the time that is shown in the touch panel on the
operation panel does not match the current time, communications that
use the timer may not be accomplished as expected. If the displayed
time is not current, be sure to adjust it to match the correct time.
Note Communication using the timer is not available in the Direct
Feed Transmission mode.
Each communication that uses the timer can be set to begin at
any minute between 00:00 - 23:59.
A maximum of 50 communications (including any combination of
communications that use the timer, Interrupt Transmissions and
Standby Transmissions) can be scheduled at one time.
When 2 or more communications that use the timer are scheduled
to begin at the same time, fundamentally each communication will
be accomplished in the order that they were registered. However,
even if it has been registered later, any communication that
scheduled with a single location will take priority over a
communication to multiple locations.
It is possible to cancel or change the contents of a communication
that is waiting for a start time, (Refer to Managing Information for
a Scheduled Communication (Editing a Communication in
Memory) on page 3-16.)
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
Note When the documents are set on the platen, it is
necessary, after each page is scanned, to select whether or
not you want to transmit more pages and to select the size of
each page. (Refer to page 2-8.)
Press start key to transmit
Dest
Ready for fax transmission.
Basic Application
DuplexAddress
Register
TXbook
Print Report
1234_.
Abbrev.
One touch
destinat.
Delayed TX
Original
Size
Original
Image
De
Mo
8½×11" Normal
To Next Page
Loading...
Need help?
General
