Fax Operation (Basic) 2-9
Receiving Documents Automatically
(Automatic Fax Reception)
Automatic Fax Reception is the default setting for fax reception in this
machine and no special settings are required for its use. The data for an
incoming fax are stored and then printed out in a single batch at the end
of the communication.
Reception modes
This fax machine offers the following 4 or 5 (depending upon the region
of use) ways to receive a fax.
• Automatic Fax Reception....Refer to this page.
• Manual Fax Reception.....Refer to page 3-22.
• Auto FAX/TEL Switching.....Refer to page 6-3.
• TAD Reception.....Refer to page 6-5.
• D.R.D. Reception.....Refer to page 6-7.
> Checking the reception mode
Make sure that Auto RX is displayed.
> Changing the reception mode
1 Press the reception mode select key when you want to change the
reception mode.
2 Press the key that corresponds to the desired reception mode.
1 Receiving a fax
When a fax comes in, fax reception will begin automatically after the
amount of time equal to a designated number of rings.
Note In order to use the Automatic Fax Reception mode, it is
necessary to select the [Fax Reception] ([Fax Rx]) key under
Selecting the Automatic Reception Mode (Receive Mode setting)
on page 6-17.
ion
TX
Register
Re-dial
On-hook
setting
Dest.
check
Memory TX
Auto RX
Print Report
Memory usage:
JUN-06-2007 16:00
Receive Mode
Manual RX
Answering
Machine
Ready for fax transmission.
Auto RX
Note Once fax reception begins, the [Status] ([Act status]) key
will appear in the bottom right of the touch panel.
To Next Page
Loading...
Need help?
General
