3-22 Fax Operation (Advanced)
Initiating the Fax Connection Manually
(Manual Fax Reception)
Once you are connected with the other party, reception can be initiated
manually by pressing the Start key. Use this mode when you want to talk
to the other party prior to actual reception of the documents.
Preparation
Make sure that [Manual RX] is displayed. If it is not, press the reception
mode select key and then press the [Manual RX] key.
1 When a call comes in, the separately purchased phone will ring.
2 Pick up the telephone receiver.
3 Check whether or not the call is from a fax.
> If you hear a fax tone...
You are connected to a fax machine.
Press the Start key. Fax reception will begin.
> If the other party’s voice can be heard...
You are connected to a telephone.
Note Conversation with the other party is only possible if a
separately purchased telephone is connected to this fax machine.
Auto Fax Reception is the default setting in this fax, so, in order to
manually initiate reception, it is usually necessary to change the
reception mode to Manual Fax Reception.
ion Register
Re-dial
On-hook
Dest.
check
Memory TX
Manual RX
Print Report
Memory usage:
JUN-06-2007 16:00
TX
setting
Note If the separately purchased telephone has tone dialing
capabilities, you can use the Remote Switching function.
(Refer to Initiating Fax Reception From A Connected
Telephone (Remote Switching) on page 3-24.)
To Next Page
Need help?
General
