Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Display elements and function keys
7
7.2
7.2.3
7.2-4
EDSVF9333V EN 3.0-06/2005
ExplanationMeaningDisplay
Number
Menu level With active level:
Submenu number
Only active for operation with
basic devices of 8200 vector or
8200 motec series
Code level With active level:
Two-digit subcode number
Parameter value
Parameter value with unit
Cursor
In the parameter level, the figure
above the cursor can be directly
changed
Function keys
For description see the following
table
Note!
Key combinations with :
Press and keep it pressed, then press the second key in
addition.
Key
Function
Menu level Code level Parameter level Operating level
Change to the
parameter level
Change to the
operating level
Change to the code
level
Load predefined
configurations in
the menu
”Short setup”
1)
Accept parameters
when SHPRG or
SHPRG is displayed
Change between
menu items
Change of code
number
Change of figure
above cursor
Quick change
between the menu
items
Quick change of
code number
Quick change of
figure above cursor
Change between main menu, submenus
and code level
cursor to the right
cursor to the left
Cancel the function of key , the LED in the key is off
Inhibit controller, the LED in the key is lit
Reset the fault
(TRIP reset):
1. Remedy the cause of malfunction
2. Press
3. press
1)
Only active for operation with basic devices of 8200 vector or 8200 motec series
Function keys
To Next Page
Loading...
Need help?
General
