Configuration
Code table
8
8.3
8.3-25
EDSVF9333V EN 3.0-06/2005
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0366 Sync Response 1
0 No response
Response to sync telegram of the
master
1 Response
C0367 Sync Rx ID 128 1 {1} 256 Receipt identifier (Rx)
z Sync Identifier for grouping for
data transfer to CAN-IN1
C0368 SYNC TX ID 128 1 {1} 256 Transmission identifier (Tx)
z Identifier for generating a sync
telegram
C0369 SYNC TX TIME 0 0 {1} 65000 Sync transmission time (Tx)
z Transmission interval for the
object set in C0368
C0400 DIS: OUT -199.99 {0.01 %} 199.99 Analog output signal, function
block AIN1
z Read only
See System
Manual
(extension)
C0402
CFG: OFFSET 19502 FCODE-26/1 Selection list 1 Configuration offset, function
block AIN1
z The offset is added to the
input signal at AIN1 -IN
C0403
CFG: GAIN 19504 FCODE-27/1 Selection list 1 Configuration of gain, function
block AIN1
z The gain is multiplied by the
input signal at AIN1 -IN
C0404 -199.99 {0.01 %} 199.99
Function block AIN1
z Display of the signals linked in
C0402 and C0404
1 DIS: OFFSET
2 DIS: GAIN
C0405 DIS: OUT -199.99 {0.01 %} 199.99 Analog output signal, function
block AIN2
z Read only
See System
Manual
(extension)
C0407
CFG: OFFSET 19503 FCODE-26/2 Selection list 1 Configuration of offset, function
block AIN2
z The offset is added to the
input signal at AIN2 -IN
C0408
CFG: GAIN 19505 FCODE-27/2 Selection list 1 Configuration of gain, function
block AIN2
z The gain is multiplied by the
input signal at AIN2 -IN
C0409 -199.99 {0.01 %} 199.99
Function block AIN2
z Display of the signals linked in
C0407 and C0408
1 DIS: OFFSET
2 DIS: GAIN
C0420
ENCODER
CONST
512 1 {1 inc/rev} 8192 Number of increments for
incremental encoder at X8 or X9
z Connect incremental encoders
with HTL-level on X9 only
6.7-1
C0421
ENC VOLTAGE 5.00 5.00 {0.1 V} 8.00 Supply voltage for the
incremental encoder at X8
CAUTION! A wrong entry can
destroy the incremental encoder!
To Next Page
Loading...
Need help?
General
