5.13.- DISPLAY
In this point the lighting status of the screen and its
language can be configured.
Press the key to enter editing mode. It is
identified by the symbol and the blinking of
the digits to be modified
The following display configuration options are available:
ON: the display light is always on.
OFF: the light is always off.
AUTO: the light comes on when a key is pressed and switches off when no keys have
been pressed for 5 minutes.
The light level is also congured between 0 % and 100 % when the display is on.
The display language options are as follows:
ESP: Spanish.
EnG: English.
FrA: French.
The key increases the digit value or shows the next option.
The key decreases the digit value or shows the next option.
The key skips to the previous parameter.
The key skips to the next parameter.
Press to validate the data; the symbol disappears from the display.
Press the key to access the next programming step.
If no keys are pressed for 5 minutes, the unit switches to the simulation screen, “5.27.-
SIMULATION SCREEN”.
87
To Next Page
Loading...
Need help?
General
