5.17.- CPC-NET COMMUNICATIONS
In this point the CPC-NET communication
parameters can be configured.
Press the key to enter editing mode. It is
identified by the symbol and the blinking of
the digits to be modified.
The parameters to be configured are:
The transmission speed, BaudRate: 9600, 19200 or 38400.
The parity:
none: no parity.
Even: even parity.
Odd: odd parity
The number of stop bits: 1 or 2
The key increases the digit value or shows the next option.
The key decreases the digit value or shows the next option.
The key skips to the previous digit or the previous parameter.
The key skips to the next digit or the next parameter.
Press to validate the data; the symbol disappears from the display.
If the value entered is lower than the minimum value or higher than the maximum value,
the backlight of the display ashes and the value entered is replaced with the minimum or
maximum value, or with the last value validated.
Press the key to access the next programming step.
If no keys are pressed for 5 minutes, the unit switches to the simulation screen, “5.27.-
SIMULATION SCREEN”.
91
To Next Page
Loading...
Need help?
General
