Warning symbol on the connector of the rear seat
belt status indicator
X
Press seat belt buckle : on the grooved
surface and remove seat belt buckle :
from holder =.
i
When the ignition is switched on, a mes-
sage is displayed for the corresponding
rear seats in the upper multifunction dis-
play. If, for example, both connectors are
removed, the message: 7No rear
seat belt engaged appears.
X
Stow connector : in connector
holder ; in the vehicle floor.
X
Pull lever = upwards and hold it securely.
X
Pull left-hand or right-hand release han-
dle ? on backrest A.
Corresponding seat backrest A is
released.
X
Fold backrest A forwards past the vertical
to an angle of approximately 20Ëš.
X
Hold backrest A with your free hand and
lift the backrestby pulling lever =.
i
Forgreater convenience, there is a recess
on the rear of the â…”backrestwhich makes
it easier to grasp the backrest.
X
Remove backrest A from the vehicle
through the rear door.
Fitting the backrest
X
Place the backrest, starting with the seat's
front feet, onto the locking bolts in
recesses :.
Stowage areas
197
Stowing and features
Z
To Next Page
Loading...
Need help?
General
