Further information on tested and approved
engine oils can be obtained from any
Mercedes-Benz Service Centre. Mercedes-
Benz recommends that youhave the oil
change carried out at a Mercedes-Benz
Service Centre. Mercedes-Benzapproval is
indicated on the oil container by the inscrip-
tion "MB Approval" and the corresponding
designation, e.g. MB Approval 229.51.
The table shows which engines oil have been
approved for your vehicle.
Petrol engines MB Approval
A 160
A 160
48
A 180
A 180
48
A 200
A 200 TURBO
229.3, 229.31,
229.5, 229.51
Diesel engines MB Approval
Vehicles without adiesel particle fil-
ter
49
A 160 CDI
A 160 CDI
48
A 180 CDI
A 200 CDI
228.3, 228.5,
228.51, 229.3,
229.31, 229.5,
229.51
Vehicles with adiesel particle filter
A 160 CDI
A 160 CDI
48
A 180 CDI
A 200 CDI
228.51,
229.31, 229.51
You can call up an overview of approved
engine oils on the Internet at
http://bevo.mercedes-benz.com by enter-
ing the designation, e.g. 229.5.
i If the engine oils listed in the table are not
available, you may add a maximum of 1.0l
of the following engine oils, once only, until
the next oil change:
R
vehicles with a petrol engine: MB
Approval 229.1 or ACEA A3
R
vehicles with a diesel engine: MB
Approval 229.1 or ACEA C3
Capacities
The following values refer to an oil change
including the oil filter.
Vehicle model Replacement
amount with oil fil-
ter
A 160
A 160
50
A 180
A 180
50
A 200
A 200 TURBO
5.0 l
A 180 CDI
A 200 CDI
5.4 l
A 160 CDI
A 160 CDI
50
6.0 l
Additives
!
Do not use additives in engine oil. This
could damage the engine.
Engine oil viscosity
Viscosity describes the flow characteristics
of a fluid. If an engine oil has a high viscosity,
this means that it is thick; a low viscosity
means that it is thin.
Engine oil selection is based on the respective
outside temperatures and in accordance with
the SAE classification (viscosity). The table
48
BlueEFFICIENCY.
49
Only for certain countries.
50
BlueEFFICIENCY.
Service products and capacities
257
Technical data
Z
To Next Page
Loading...
Need help?
General
