4-10 Exam Preparation
If you want to continue an exam which data lies in an external memory database, you have to
first allow the system to load the patient data to the system’s patient database.
4.6 Pause & End an Exam
4.6.1 Pause and Exam
Sometimes, you have to stop an uncompleted exam due to some special causes. When
the exam is paused, the system can begin other exams.
1. Press <Patient> to enter "Patient Info" screen.
2. Click [Pause Exam].
If the system is powered off during scanning, the exam status turns "paused" after the
system restart.
Only one exam can be paused every time.
When an exam is paused, the system will:
1. Saves the exam-related images, reports and measurement data, modifies the status as
“Paused”.
2. Save the exam information, including report, imaging mode, exam mode, image
parameters, operation mode, imaging / measurement data and so on.
4.6.2 End an Exam
Before examining a new patient, press <End Exam> to end the exam of the previous patient,
update the patient ID and information, to avoid mixing data of the next new patient.
To end an exam, you can do one of the following:
Press <End Exam> on the control panel.
Click [New Patient] on the Patient Info screen to end the last patient exam and clear
the patient information.
Click [New Exam] on the Patient Info screen (or iStation screen, or Review screen) to
end the last exam and clear the exam data.
To Next Page
Loading...
Need help?
General
