iWorks (Auto Workflow Protocol) B-1
Appendix B iWorks (Auto Workflow
Protocol)
B.1 Overview
The major objective of ultrasound workflow automation (iWorks) is to speed up exam time and reduce
the excessive number of user interface manual key strokes that can lead to repetitive motion injuries
over time. It automates a clinical workflow in common exam protocols in a logical, “step by step”
manner. It also prevents missing an important part of an examination as well as decreases exam time.
A Protocol Event contains series workflow events (annotation comments, body mark and
measurements) and image modal commands to assist the user in routine ultrasound examinations.
The system provides different protocol events based on the different application regions.
iWorks is an option.
B.2 Normal iWorks Basic Procedure
1. Enter the patient information.
2. Press iWorks user-defined key to enter the protocol selection screen, and select the corresponding
protocol button to enter the status.
3. After the system enters the iWorks screen, the available protocol is displayed on the lower part of
the screen, perform the scanning and saving according to the screen prompt.
Perform measurements or add comment/body mark to the image according to the screen prompt.
4. After one view scanning is completed, press the user-defined save key (usually <Save1> or
<Save2>) to switch to the next view according to the screen prompt.
5. Repeat step 3 and step 4 to acquire all necessary images.
6. After all views are finished, the system will prompt you if to exit iWorks, click [Yes] to exit.
To Next Page
Loading...
Need help?
General
