To Next Page

To Previous Page

9 Visualization

Maschinenfabrik Reinhausen GmbH 2020 2956385142/08 EN ETOS

4. Press the Export button to start the export.

Configuring AIO

1. Go to Settings > AIO configuration.

2. Configure properties such as function, signal type and card/channel.

3. Select the button to configure the values as desired.

Figure222: Entering values

4. Press the Accept button.

5. Confirm the security prompt with Save to save the changes.

9.30 Configuring digital inputs and outputs

Upon delivery, the configurable digital inputs and outputs of the device are

configured as follows:

▪ Input: High active

▪ Output: N/O contact (NO)

You can change this configuration if necessary.

If you have connected sensors over the MR sensor bus, you must select the

"Modbus" signal type for the desired functions. Observe the additional infor-

mation provided in the MR sensor bus [►Section 9.28, Page 282] section.

Ensure that the configuration of the digital inputs and outputs is suitable for

the functions used. Otherwise, malfunctions may occur in the device and

the connected periphery.

The following information is displayed in tabular form for configuring the digi-

tal inputs and outputs. Grayed out elements cannot be changed.

Questions and Answers:

Need help?

Do you have a question about the MR ETOS ED and is the answer not in the manual?

MR ETOS ED Specifications

General