mycom 3225**C Series User Manual

2202MYJE-MY-C8-N_2018.02.
Chapter 1 Safety
Compound 2-stage Screw Compressor 3225**C 1.3 Residual Risks
1-4
1.3 Residual Risks
The following information assumes that this product is operated or inspected/maintained while being
used in general refrigerating/cold storage/gas compression package units.
Note that all hazardous sources cannot be predicted for the applications mentioned.
Devise appropriate countermeasures for hazardous sources in your systems.
Table 1-2 Hazardous Sources
Hazardous sources
Predicted hazard
Countermeasures in
operation
Countermeasures in
cleaning, inspection,
and parts exchange
A
Motor and
compressor coupling
Refer to Figure 1-1
 Caught in due to contact
 Install coupling cover
and prohibit opening.
 Keep away.
 Turn off motor main
power and control
power, and conduct
lockout/tagout.
B
Motor terminals
 Electric shock caused by
contact with live wires or
electrical leakage
 Keep away.
 Do not open terminal
boxes.
 Do not touch terminal
boxes.
 Turn off motor main
power and control
power, and conduct
lockout/tagout.
C
Compressor
low-stage side
suction casing
Refer to Figure 1-1
 Frostbite due to contact
 Contact with or inhalation of
hazardous substances
generated by leakage of
refrigerant or the like
 Keep away and do not
touch.
 Wear protective gear.
 Detect gas leakage.
 Wear protective gear.
 Work under room
temperature.
D
Compressor
intermediate piping
(low-stage discharge
port to high stage
suction port)
Refer to Figure 1-1
 Burn injury due to contact
 Contact with or inhalation of
hazardous substances
generated by leakage or
spout of refrigerant or the like
 Keep away and do not
touch
 Wear protective gear
 Gas leakage detection
 Wear protective gear
 Work in temperatures
below 40 °C
E
Compressor
high-stage side
discharge casing and
discharge piping
 Burn injury due to contact
 Contact with or inhalation of
hazardous substances
generated by leakage or
spout of refrigerant or the like
 Keep away and do not
touch.
 Wear protective gear.
 Detect gas leakage.
 Wear protective gear.
 Work at a temperature
of not higher than 40°C.
F
Check valves/service
valves and joints on
each section of the
package unit
 Contact with or inhalation of
hazardous substances
generated by mishandling or
leakage
 Frostbite or burn due to
contact
 Sufficient ventilation
 Indicate valve
open/close state.
 Keep away and do not
touch.
 Wear protective gear.
 Sufficient ventilation
 Wear protective gear.
 Tagout for controlled
valve
G
Solenoid
valves/electric valves
on each section of the
package unit
 Electric shock caused by
contact with live wires or
electrical leakage
 Pinched due to contact with
driving part
 Install protective cover
on terminals, and
prohibit opening.
 Keep away and do not
touch.
 Wear protective gear.
 Turn off each breaker
and the control power,
and conduct
lockout/tagout.
 Wear protective gear.
H
Electric components
in each section of the
package unit (oil
heater, protective
switch, etc.)
 Electric shock caused by
contact with live wires or
electrical leakage
 Pinched due to contact with
driving part
 Install protective cover
on terminals, and
prohibit opening.
 Keep away and do not
touch.
 Wear protective gear.
 Turn off each breaker
and the control power,
and conduct
lockout/tagout.
 Wear protective gear.
I
Package unit oil
drains
 Contact with hazardous
substances generated by
leakage or spout
 Burn caused by contact with
high-temperature fluid
 Sufficient ventilation
 Keep away and do not
touch.
 Wear protective gear.
 Sufficient ventilation
 Wear protective gear.
 Work at a temperature
of not higher than 40°C.
J
Noises
 Damage caused by noise
 Wear protective gear.
—

mycom 3225**C Series Specifications

General

Brand	mycom
Model	3225**C Series
Category	Compressor
Language	English