Configure Switching
134
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
Configure IGMP Snooping
You can configure the parameters for IGMP snooping, which is used to build forwarding lists
for multicast traffic.
 To configure IGMP snooping:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 9.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > Multicast > IGMP Snooping > IGMP Snooping Configuration.
The following figure does not display all information on the page.
6. Select the IGMP Snooping Status Enable or Disable radio button.
This specifies the administrative mode for IGMP snooping for the switch. The default is
Disable.
7. Select the Validate IGMP IP header Enable or Disable radio button.
When IGMP IP header validation is enabled, any IGMP IP header must include the
Router Alert, ToS, and TTL information. Otherwise, the IGMP packet is discarded. The
default is Disable.
To Next Page
Loading...
Need help?
General