Maintenance
289
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Maintenance > Troubleshooting > Ping IPv6.
6. In the IPv6 Address/Hostname field, enter the IPv6 address or host name of the station
that must be pinged.
The format is xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx. The maximum number of
characters is 255.
7. In the Count field, enter the number of echo requests that must be sent.
The range is 1 to 15. The default is 3.
8. In the Interval field, enter the time in seconds between ping packets.
The range is 1 to 60. The default is 3.
9. In the Datagram Size field, enter the datagram size.
The valid range is 0 to 13000. The default is 0 bytes.
10. Click the Apply button.
The specified address is pinged. The results are displayed below the configurable data in
the Results field.
Enable and Perform Remote Diagnostics
You can enable or disable the option to access the switch remotely. When remote access is
enabled, you can perform diagnostics services.
 To enable remote diagnostics:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
To Next Page
Loading...
Need help?
General