50 NIBE F1330
Control
Control
Changing a parameter
Changing a parameter (value):
Q Access the required menu.
Q Press the enter button, the numerical value starts to
flash
Q Increase or decrease the value using the plus respective
minus button.
Q Confirm by pressing the enter button.
Q Menu 1.0 is automatically displayed again 30 minutes
after pressing the last button.
Example
Changing the Menu type, menu 8.1.1.
Q The starting point is menu 1.0.
Q Press the plus or minus button several times until menu
8.0 is shown.
Q Press the enter button to move to menu 8.1.0
Q Press the enter button to move to menu 8.1.1
Q Press the enter button to allow the value to be
changed.
Q The value now starts to flash. Change the value using
the plus or minus buttons.
Q Confirm the selected value by pressing the enter but-
ton, the value will then stop flashing.
Q Press the minus button to move to menu 8.1.5
Q Press the enter button to return to menu 8.1.0
Q Press the plus button 3 times to move to menu 8.4
Q Press the enter button to return to menu 8.0
Q Press the plus or minus button several times to move to
menu 1.0
8.0 Other settings
[N]
8.1.0 Display settings
[N] 8.1.1 Menu type [N]
8.1.2 Language [N]
8.1.3 Display contrast [N]
8.1.4 Light intensity [N]
8.1.5 Return to 8.1.0
[N]
8.2.0
Operatingmode
setting
[U] 8.2.1 Only additional heat [U]
8.2.2 Changing temperature [U]
8.2.3 Start value compr. [U]
8.2.4 GM for compr.step [U]
8.2.5 Additive start value [U]
8.2.6 GM for additive step [U]
8.2.7 Flow diff HP [U]
8.2.8 Diff HP-Add [U]
8.2.9 Return to 8.2.0
[U]
8.3.0 Load monitor
[U] 8.3.1 Fuse size [U]
8.3.2 Max electric power [U]
8.3.3 Current phase 1 [U]
8.3.4 Current phase 2 [U]
8.3.5 Current phase 3 [U]
8.3.6 Ratio of transf. EBV [U]
8.3.7 Tariff status [U]
8.3.8 Return to 8.3.0
[U]
8.4 Return to 8.0
[N]
[N]
Normal menus: Displayed in all menu modes.
[U]
Extended menus: Only displayed when extended or
service is selected in menu 8.1.1.
[S]
Service menus: Only dispalyed when service is selected
in menu 8.1.1
To Next Page
Loading...
Need help?
General
