4-3-3. Edit Station record
The system will not recalculate all measurements based on the
change in Station. All Coordinate and RAW data observed from
edited ST must be recalculated in your post-processing software.
3
MENU: 4. Data
If you need to modify the ST record, place the
cursor on the ST you are to change.
Press the white key beneath the [Edit] softkey.
All items in the ST record can be edited but no
recalculation will be performed on the instrument.
Press [ENT] in the last field (AZ) to confirm the
change.
• Even if the STN point and/or Height of Instrument is changed, coordinate of the
observation points are not re-calculated on the instrument. Only a comment record
to indicate the change is to be recorded.
Ex.) CO,HI changed at ST:9012 Old HI= 1.3456m
• Also, the RAW records are not re-calculated when BS point and/or BS Azimuth is
changed. Only a CO record is to be stored.
4-4. Search Record
You can search for records by their type, point number/name, code, or by any
combination of those.
4-4-1. Search from RAW record
Press the [Srch] softkey to activate the RAW data
search function.
3-114
To Next Page
Loading...
Need help?
General
