5.2 European Standards
172 SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
◆ CE Low Voltage Directive Compliance
This product is tested according to IEC/EN 61800-5-1:2007 and complies with the CE Low Voltage Directive.
The following conditions must be satisfied for machines and devices incorporating this product to comply with
the CE Low Voltage Directive.
■ Area of Use
Install this product in a location with overvoltage category III and pollution degree 2 or less. These standards are
defined by IEC/EN 60664.
■ Guarding against Debris
When installing IP20 enclosure drives, use an enclosure that does not let unwanted material enter the drive from
above or below.
■ Wiring Diagram
Example of a drive that is wired to comply with the CE Low Voltage Directive.
To Next Page
Loading...
Need help?
General
