7. Drive/Shutter
147
îš™
Operations during Time Lapse Shot Recording
Pressing the shutter button halfway during sleep status will turn on the
camera.
0
You can perform the following operations by pressing [Q] during Time Lapse Shot
recording.
[Continue] Returns to the recording. (Only during recording)
[Pause] Pauses the recording. (Only during recording)
[Resume]
Resumes the recording. (Only while paused)
0 You can also press the shutter button halfway to resume.
[End] Stops the Time Lapse Shot recording.
0 Pictures recorded to more than one card cannot be combined into a single
video.
0 Group images containing pictures taken with [HLG Photo] cannot be
converted to videos.
0 The camera gives priority to achieving the correct exposure, so it may not take
pictures at the set interval or take the set number of pictures.
Furthermore, it may not end at the end time displayed on the screen.
0 Time Lapse Shot is paused in the following cases.
– When the charge on the battery runs out
– When you set the camera on/off switch to [OFF]
You can set the camera on/off switch to [OFF] and replace the battery or
card.
Set the camera on/off switch to [ON] and then press the shutter button fully
to resume recording.
(Note that the images recorded after replacing the card will be saved as a
separate set of group images.)
0 [Exposure Leveling] is not available in [M] mode if the ISO sensitivity is set to
other than [AUTO].
0 [Time Lapse Shot] is not available when using the following functions:
– [High Resolution Mode]
– [Post-Focus]
– [Multiple Exposure]
To Next Page
Loading...
Need help?
General
