Coolant replacement
Emptying
- Remove the right side fairing.
- Remove the right lower spoiler.
- Unscrew and remove the expansion tank cap.
- Slide off the sleeve after loosening the clamp.
- Let the coolant drain into a container of adequate
capacity.
Filling
- Connect the sleeve and fix it with the clamp.
- Open the bleed valve.
- Fill the coolant from the expansion tank.
- Once the coolant drains out of the bleed valve
without air bubbles, close the screw, close the ex-
pansion tank, start the scooter and warm it up.
- Wait for the engine to cool down.
- Carry out the bleed operation again, inside the expansion tank, if the coolant has not reached the level
indicated.
- Restore the level in the expansion tank.
Thermostat
Removal
- Remove the helmet compartment.
- Remove the side spoiler.
- Empty the cooling circuit.
- Remove the thermostat cover.
Cooling system Carnaby 125 - 200
COOL SYS - 236
To Next Page
Loading...
