Spark plug 12 ÷ 14
When refitting, place the spark plug into the hole at the due inclination and tighten it manually all the
way down. Use the wrench only to tighten it. Once locked, insert the cap «D» on the spark plug. Refit
the covers.
Hub oil
Check
-Stand the vehicle on its centre stand on flat
ground;
- Remove the oil dipstick «A», dry it with a clean
cloth and put it back into its hole tightening it
completely;
-Take out the dipstick checking that the oil level
reaches the dipstick lower notch; if the level is un-
der the MAX. mark, it needs to be filled with the
right amount of hub oil.
-Screw up the oil dipstick again and make sure it
is locked properly into place.
The notches on the hub oil level dipstick, except
for the notch indicating the MAX level, refer to oth-
er manufacturer's models and have no specific
function for this model.
Replacement
-Remove the oil filler cap «A».
- Remove the exhaust silencer.
- Remove the rear wheel.
- Remove the brake calliper and the rear brake
disc.
Maintenance Carnaby 125 - 200
MAIN - 46
To Next Page
Loading...
Need help?
General