9 – Device Security Configuration
Resetting the Security Database
9-10 59263-01 A
S
Resetting the Security Database
There are two ways to remove all groups and security sets from the security
database:
îš„ Enter the Security Clear command as shown in the following example:
SANbox (admin-security) #> security clear
All security information will be cleared. Please confirm (y/n): [n] y
SANbox (admin-security) #> security save
îš„ Enter the Reset Security command as shown in the following example. The
security configuration values, autosave and fabric binding remain
unchanged.
SANbox (admin) #> reset security
Managing Security Sets
Managing Security Sets consists of the following tasks:
îš„ Create a Security Set
îš„ Delete a Security Set
îš„ Rename a Security Set
îš„ Copy a Security Set
îš„ Add Groups to a Security Set
îš„ Remove Groups from a Security Set
îš„ Activate a Security Set
îš„ Deactivate a Security Set
All of these tasks except Activate a Security Set and Deactivate a Security Set
require a Security Edit session.
Create a Security Set
Enter the Securityset Create command to create a new security set as shown in
the following example:
SANbox (admin-security) #> securityset create securityset_1
Delete a Security Set
Enter the Securityset Delete command to delete a security set as shown in the
following example:
SANbox (admin-security) #> securityset delete securityset_1
To Next Page
Loading...
Need help?
General
