6 – Port Configuration
Resetting a Port
6-10 59263-01 A
S
Enter the Set Config Security Portbinding command to enable port binding for the
selected port and to specify the world wide names of the authorized ports/devices.
The following example enables port binding on port 1 and specifies two device
world wide names.
SANbox #> admin start
SANbox (admin) #> config edit
SANbox (admin-config) #> set config security port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PortBindingEnabled (True / False)[False] true
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f9
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f8
WWN (N=None / WWN)[None ] n
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
Resetting a Port
Enter the Reset Port command to reinitialize one or more ports and to discard any
temporary changes that have been made to the administrative state or link speed.
The following example reinitializes port 1:
SANbox #> reset port 1
To Next Page
Loading...
Need help?
General
