4 – Network Configuration
Managing IP Security
4-18 59263-01 A
S
Renaming a User-Defined Association
To rename a user-defined association (associaton_1), enter the
Ipsec Association Rename command as shown in the following example:
SANbox #> admin start
SANbox (admin) #> ipsec edit
SANbox (admin-ipsec) #> ipsec association rename association_1 association_4
The security association will be renamed. Please confirm (y/n): [n] y
SANbox (admin-ipsec) #> ipsec save
The IPsec configuration will be saved and activated.
Please confirm (y/n): [n] y
Copying an Association
You can copy both user-defined and dynamic associations. To copy an
association (association_1), enter the Ipsec Association Copy command as
shown in the following example:
SANbox #> admin start
SANbox (admin) #> ipsec edit
SANbox (admin-ipsec) #> ipsec association copy association_1 association_a
SANbox (admin-ipsec) #> ipsec save
The IPsec configuration will be saved and activated.
Please confirm (y/n): [n] y
Resetting the IP Security Configuration
Resetting the IP Security configuration deletes all policies and associations from
the switch. There are two ways to do this. Within an Ipsec Edit session, enter the
Ipsec Clear command, then save the changes as shown in the following example:
SANbox #> admin start
SANbox (admin) #> ipsec edit
SANbox (admin-ipsec) #> ipsec clear
SANbox (admin-ipsec) #> ipsec save
The IPsec configuration will be saved and activated.
Please confirm (y/n): [n] y
To Next Page
Loading...
Need help?
General
