5 – Switch Configuration
Setting the Date and Time
5-18 59263-01 A
S
Setting the Date and Time Explicitly
To set the switch date and time explicitly, use the Set Timezone and Date
commands. To change the time zone (to America/North Dakota, for example),
enter the Set Timezone command in an Admin session, as shown in the following
example:
SANbox #> admin start
SANbox (admin) #> set timezone
Africa America
Antarctica Asia
Atlantic Australia
Europe Indian
Pacific UTC
Press ENTER for more options or 'q' to make a selection.
America/Grenada America/Guadeloupe
America/Guatemala America/Guayaquil
America/Guyana America/Halifax
America/Havana America/Hermosillo
America/Indiana America/Indianapolis
.
.
.
America/Monterrey America/Montevideo
America/Montreal America/Montserrat
America/Nassau America/New_York
America/Nipigon America/Nome
America/Noronha America/North_Dakota
America/Panama America/Pangnirtung
Press ENTER for more options or 'q' to make a selection.
q
Enter selection (or 'q' to quit): america/north_dakota
America/North_Dakota/Center
Enter selection (or 'q' to quit): america/north_dakota/center
To set the date and time (January 31, 10:15 AM, 2008), enter the date command,
as shown in the following example:
SANbox (admin) #> date 013110152008
SANbox (admin) #> date
Thu Jan 31 10:15:03 america/north_dakota/center 2008
To Next Page
Loading...
Need help?
General
