5 – Switch Configuration
Managing Switch Configurations
5-12 59263-01 A
S
Managing Switch Configurations
The switch configuration determines the basic operational characteristics of the
switch. A switch can save up to 10 configurations including the default
configuration, named Default Config. The current switch operating characteristics
are determined by the active configuration. Only one configuration can be active
at one time.
Each switch configuration contains switch, port, port threshold alarm, and zoning
configuration components. Managing Switch Configurations describes the
following tasks:
îš„ Displaying a List of Switch Configurations
îš„ Activating a Switch Configuration
îš„ Copying a Switch Configuration
îš„ Deleting a Switch Configuration
îš„ Modifying a Switch Configuration
îš„ Backing Up and Restoring a Switch Configuration
Displaying a List of Switch Configurations
Enter the Config List command to display the configurations stored on the switch
as show in the following example. Notice that the Config List command does not
require an Admin session.
SANbox #> config list
Current list of configurations
------------------------------
default
config_1
config_2
Activating a Switch Configuration
Enter the Config Activate command in an Admin session to activate a switch
configuration (config_1) as shown in the following example:
SANbox (admin) config activate config_1
Copying a Switch Configuration
Enter the Config Copy command in an Admin session to create a copy of an
existing configuration as shown in the following example:
SANbox (admin) config copy config_1 config_2
To Next Page
Loading...
Need help?
General
