5 – Switch Configuration
Setting the Date and Time
59263-01 A 5-19
A
Setting the Date and Time through NTP
An NTP server can automatically set the switch date and time. To configure the
switch to use an NTP server, enter the Set Setup System Ntp command in an
Admin session to enable the NTP client on the switch and specify the NPT server
IP address, as shown in the following example:
SANbox (admin) #> set setup system ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
NTPClientEnabled False
NTPServerDiscovery Static
NTPServerAddress 10.20.10.10
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
NTPClientEnabled (True / False) : True
NTPServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
NTPServerAddress (hostname, IPv4, or IPv6 Address) : 10.20.3.4
Do you want to save and activate this system setup? (y/n): [n] y
To Next Page
Loading...
Need help?
General
