2 – Command Line Interface Usage
Logging In to the Switch
2-2 59263-01 A
S
Logging In to the Switch
To log in to a switch through Telnet, do the following:
1. Open a command line window on the workstation and enter the Telnet
command followed by the switch IP address. The IP address can be one of
the following:
îš„ 4-byte IP version 4 address
îš„ 16-byte IP version 6 address
îš„ Domain Name System (DNS) host name (requires a DNS server)
The Telnet window opens prompting you for a login.
# telnet ip_address
2. Enter an account name and password. The default account name is admin,
and its password is password.
switch login:admin
password: xxxxxxxx
The following warning appears when you log in for the first time:
Warning: Your user account password has not been changed
It is strongly recommended that you do so before
proceeding
To log off, enter the Exit command:
SANbox #> exit
To log in to a switch through the serial port, do the following:
1. Configure the workstation port with the following settings:
îš„ 9600 baud
îš„ 8-bit character
îš„ 1 stop bit
îš„ No parity
2. Enter an account name and password when prompted. The default account
name is admin, and its password is password.
To Next Page
Loading...
Need help?
General
