4 – Network Configuration
Configuring the Ethernet Port
59263-01 A 4-5
A
DNS Server Configuration
A DNS server manages the host names for a fabric. This enables you to specify
servers and switches by a meaningful name rather than IP address. To configure
a DNS server, enter the Set Setup System Dns command in an Admin session as
shown in the following example:
SANbox (admin) #> set setup system dns
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
DNSClientEnabled False
DNSLocalHostname <undefined>
DNSServerDiscovery Static
DNSServer1Address <undefined>
DNSServer2Address <undefined>
DNSServer3Address <undefined>
DNSSearchListDiscovery Static
DNSSearchList1 <undefined>
DNSSearchList2 <undefined>
DNSSearchList3 <undefined>
DNSSearchList4 <undefined>
DNSSearchList5 <undefined>
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
DNSClientEnabled (True / False) :
DNSLocalHostname (hostname) :
DNSServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
DNSServer1Address (IPv4, or IPv6 Address) :
DNSServer2Address (IPv4, or IPv6 Address) :
DNSServer3Address (IPv4, or IPv6 Address) :
DNSSearchListDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
DNSSearchList1 (domain name) :
DNSSearchList2 (domain name) :
DNSSearchList3 (domain name) :
DNSSearchList4 (domain name) :
DNSSearchList5 (domain name) :
Do you want to save and activate this system setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
