13 – Simple Network Management Protocol Configuration
Managing the SNMP Service
13-2 59263-01 A
S
Managing the SNMP Service
You control the SNMP service SNMPEnabled parameters through the
Set Setup SNMP or Set Setup Services commands. Refer to “Modifying the
SNMP Configuration” on page 13-4 for more information.
Enter the Set Setup Services command to enable SNMP as shown in the
following example:
SANbox #> admin start
SANbox (admin) #> set setup services
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PLEASE NOTE:
-----------
* Further configuration may be required after enabling a service.
* If services are disabled, the connection to the switch may be lost.
* When enabling SSL, please verify that the date/time settings
on this switch and the workstation from where the SSL connection
will be started match, and then a new certificate may need to be
created to ensure a secure connection to this switch.
TelnetEnabled (True / False) [True ]
SSHEnabled (True / False) [False]
GUIMgmtEnabled (True / False) [True ]
SSLEnabled (True / False) [False]
EmbeddedGUIEnabled (True / False) [True ]
SNMPEnabled (True / False) [True ]
NTPEnabled (True / False) [False]
CIMEnabled (True / False) [False]
FTPEnabled (True / False) [True ]
MgmtServerEnabled (True / False) [True ]
CallHomeEnabled (True / False) [True ]
Do you want to save and activate this services setup? (y/n): [n]
You can display the SNMPEnabled parameters using the Show Setup Snmp or
Show Setup Services commands.
To Next Page
Loading...
Need help?
General
